Environmental plantings and
mallee methodology determinations use the reforestation modelling tool (RMT) when calculating abatement. For both methodology determinations there are situations where establishing and re-establishing mixed carbon estimation areas are complex. These situations require specific RMT inputs.
If a carbon estimation area (CEA) is established using both direct seeding and tree planting methods it may not be feasible to stratify the CEA into seeded and planted areas. In these cases, the CEA must be modelled in the RMT using the direct seeding setting. There is one exception to the rule and that is when evidence of the density of planted stems proves the need for a tree planting density setting.
If there is partial failure of a seeding or planting, a project may be left with a successful portion of a CEA and an unsuccessful portion that needs to be re-established or excluded. Re-stratifying the area will create two new CEAs:
If there is partial failure of seeds or stems that is spread across the whole CEA, it may not be feasible to re-stratify the area into successful and unsuccessful portions. In this situation you will need to re-establish the CEA and alter the inputs to the RMT accordingly (see tables below). This will retain the conservative modelling results of the RMT.
When using the RMT select a "tree-planting-date" and "management-regime" for each CEA within your project.
Tree-planting-date means when trees have been established (i.e. seeding or planting finish date).
Management-regime means the establishment method and must be selected from:
The tables below show the options for re-establishing CEAs where re-stratification is not feasible, and the settings to use in the RMT for possible scenarios. These options can be summarised as follows:
* Assessing whether the level of success of the original establishment has more or less than 20% cover potential, and providing evidence of same, may require use of the stem density table included in the explanatory statement to the methodology determinations, and time-stamped photos and/or aerial imagery. The assessment should be conservative.
** This guidance is intended only for RMT modelling of re-established CEAs where the failure has happened in such a manner that re-stratification into successful and unsuccessful (re-established) areas is not feasible.
1 "using stem density" refers to only those circumstances in which the relevant stem density is high enough to warrant use of the medium and high stem density setting in RMT. In all other circumstances, the low stem density setting must be used.
About The Clean Energy Regulator
Carbon Farming Initiative
Carbon Pricing Mechanism
National Greenhouse And Energy Reporting
Renewable Energy Target
Emissions Reduction Fund
Our Systems And Their Resources
Clean Energy Markets
Data and information
Subscribe to email updates
The Clean Energy Regulator is a Government body responsible for accelerating carbon abatement for Australia.
Follow us on Twitter
Follow us on LinkedIn